Shotshell Carrier R - [ Sell Product ]

Place of Origin : Shenzhen,China
Post Date : 18-08-2014
Expiry Date : 18-09-2015

Trade Description

1.Remove 6 Little Hex Screws From The Shotshell Carrier To Expose Two Tapped Hole In The Mounting Plate.
2. Lay The Shotgun On Its Side With The Ejection Port Facing Down.
3. Using The Supplied Big Screw With Washer, Push Out Pin (A) Located Above And To The Rear Of The Trigger Guard. Leave Screw In Hole.
4.Turn The Shotgun Over And Place The Mounting Plate On The Receiver With The Two Corresponding Holes On The Two Screws.
5.Start Screws Into The Mounting Plate And Lightly Tighten. Do Not Overtighten. Overtightening May Lock Up The ShotgunÃƒÂ¢Ã¢â€šÂ¬Ã¢â€žÂ¢s Action. To Remedy, Simply Loosen Screws.

^{Company Inforamtion}